These are recent jobs from Houston homes—shown as they happened, not staged. You’ll see the same workflow every time: start with diagnosis, keep the plan clear, complete the repair, then verify the result before closeout.
Had to pull the top to get to the ignition and burner guts. Cleaned out heavy buildup, fixed the no-light issue, and test-lit every burner before putting it back together.
Pulled out for service, repaired, and tested under load. Heat/steam and controls verified. Unit reinstalled flush with clean fit.
Full service on a cooking suite. We calibrated oven temperature accuracy and checked the gas cooktop ignition for stable starts and consistent flame.
Restored stable operation by correcting airflow/closure issues and verifying the unit holds the set temperature under normal use.
Customer had a dead oven — no heat. We found the failed piece in the heating path, replaced it, and confirmed the oven holds temperature through a full cycle.
Steam wasn’t coming through right and cooking results were off. We serviced the steam system, cleared the issue, and ran a full test to confirm steady steam and proper heat.
Opened the top service compartment, cleaned the condenser and airflow path, and got the cooling back on track. Verified the unit holds steady temps before closing everything up.
Dryer was running but not heating. We fixed the heat issue, cleaned out the airflow path, and confirmed it dries normally on a full cycle.
Ice and water weren’t dispensing right. We fixed the root issue, checked for leaks, and verified normal dispense and ice production.